I made small miniature case, carrier shape.
We implemented all the movements of the carrier in just three parts. You do not need to use the support option in slicing since I have created the part where you need support. Enjoy~ :)
infill 10%, Layer thickness 0.1 or , Retraction (for Bowden type) or (for direct type), nozzle , print speed: 35~40mm/sec, No support, No brim, Raft is OK, Recommend filament : PLA
This setting is recommended only and may vary depending on the printer’s conditions.
14 views
686
175
10 months ago 00:00:35 35
Dial safe-multi purpose chest.
10 months ago 00:01:02 14
Multi-purpose chest carrier shape
9 years ago 00:04:04 61
Полет “ОРИОНА“
10 months ago 00:09:34 18
Мужчина строит гиперреалистичный самолет в масштабе _ Реплика По-2 от @Kashtanov Model
4 years ago 00:09:48 8
Боевое применение самолета ПО-2 (У-2) / Combat use of the PO-2 (U-2)aircraft
10 months ago 00:07:19 13
Roof Carrier for VW T1 Camper, Volkswagen van for 3D printing
1 year ago 00:06:10 1
SOAN - Mangalam (Original Mix) [UNCLES MUSIC COLORS] Indie Dance
3 years ago 00:01:14 4
[mmv/amv] Петля ► Loop // Чан А & Пак Сан Юн // Tourner Dans Le Vide