The Best Beginner 3D Printer in 2023 - Creality Ender 3 V3 SE

The Best Beginner 3D Printer in 2023 - Creality Ender 3 V3 SE This printer blows me away. Its ready print in about 10 minutes. After opening the box, you need only bolt on the the gantry and attach some wires. After setting the voltage, power on the printer and go through the auto leveling procedure. No user input is required, just select bed leveling and it goes the through the entire process of setting z offset, leveling and meshing without any input. The speed at which this Marlin based printer operates at is impressive, 180 mm/s out of the box @ 4000mm/s^2 acceleration. I say it here and now, this is the best first 3D printer a new user can buy. And you can get yours right here: Amazon US 6% off Code：06FS17DM Pergear site 6% off Code：GHY5WRX1ZT0C Canada & UK Look here: Canada UK ************************************************************************* *Please help support this channel at NO COST TO YOU. If you shop on* *Amazon, please use this link: * *I will get a small commission and it costs you nothing. * ************************************************************************* HEY YOU ABOUT TO POST SOMETHING STUPID: Yes, I know my hands are large/fat. It’s because of a heart condition I suffer from called Congestive Heart Failure. Here’s a link to some information about CHF: One of the symptoms is that it causes fluid retention, mostly in the hands, feet/ankles, and face.. ------------------------------------------------------------------------------------------------------------------- Support learnelectronics: Amazon Store: If you are shopping for electronic components, test gear or consumables please consider visiting my Amazon shop @ Patreon: Please check out and pledge a dollar if you can. It will go a long way to keeping the channel alive. It costs a bit of money to buy all the items and produce these videos. Your help is appreciated. Paypal: you’d like to send a one-time donation you can use this link: --------------------------------------------------------------------------------------------------------------------- Gear I use: Multimeter: OWON B33 Oscilloscope: KIPRIM DS1202 Signal generator: Junctek JDS8080 Component Tester: T7 Multifunction Soldering Station: Sealody ???????