I make Spoked Steel Wheels in an Industrial Style, using Rebar for the Spokes - Rebar Project

I make Spoked Steel Wheels in an Industrial Style, using Rebar for the Spokes. I love anything industrial and if it has rebar in it then it is even better, and this project is one of my favorites, maybe because of the bit where I bend the flat bar into rings, using just a hammer, I have done this before, but I have never tried to video it before. It was a fun rebar project to make and I hope you found something of use in my video or at least found it entertaining. The wheels are 215mm (8.5 inches) High, the flat bar is 6mm thick (1/4 inch), and 50mm wide (2 inches) The rebar is 26mm across the widest part. The main tools I used, were a MIG welder, angle grinder, drill, Hammer, and bench vise. Tools / Supplies, I often use are. Marking out Tools Markal Silver-Streak Metal Marker Round: Milwaukee 4pk Inkzall Black Ultra Fine Point Pens: Milwaukee Inkzall Jobsite Fine Point Black Permanent Marker 12 Pack: Locking Pliers – Vise Grips MILWAUKEE 10” Locking Pliers, Curved Jaw: Milwaukee 6“ Long Nose Locking Pliers: Milwaukee 6” Locking Clamp Regular Jaws: KNIPEX Tools Long Nose Grip Pliers: Magnets Magnetic V-Pads Kit, Magnets On Both Pad Face & Bottom: Mini Magnetic Fabrication Square Magnets Angles: 30°, 60°, 45°, 90°: “L” shape Corner Square Magnets 12°, 90° & 60° Angle Setting: My camera set-up. Canon EOS M6 Mark II Camera 15-45mm Lens: VideoMicro Rode Compact On-Camera Microphone: Camera Tripod Vanguard Alta Pro 2: The Brand of the Drill bits, and cutting/flap discs, is “Alpha“ If you can’t get them at your local hardware shop, here is a link to Alpha Tools: As an Amazon Associate, I earn from qualifying purchases. This means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make more videos like this one. Thank you very much for your support! ►►Subscribe to our Channel for more videos ►► Always use all the correct safety gear, and use your tools safely, I am not a good role model for this. Hope you found something of use in my video or at least found it entertaining. Gavin Clark DIY