Marlin 2.0 Build and Install | ANET ET4/5 | Ender 3 V2

Learn how to build and install Marlin 2.0 on your 3d Printer. In this video I user Visual Studio Code, platformio, and GitHub source code to create a custom Marlin build for the Anet 3/5 3d printers and discuss the steps to do the same for an Ender 3 V2. For the Anet 3/5, I install a custom boot-loader by using the STlink programmer tool and software. This is the most complex video I have produced for the MakeWithTech channel. The material is tricky to get right, the 3d printer calibration steps are complex to do consistently, the storytelling is complicated to make clear and I wish I had the time to do it all over again because it is still too long and could be improved. In the past when I have cut the material into multiple videos people watched part two so I left this video as a massive 40-minute video. Feel free to watch it in multiple seatings. The full slide deck is available on the DrVAX user forum. Point your browser at . Registration is completely free and